CAMBRIDGE QT Installationsanleitung PDF herunterladen (Seite 27)

page 27

Errors

If the control module is operating properly, software will display

“Status: Ok”. If the control module encounters an error, software will

display “Status: Error”. Click on “Error” to obtain additional informa-

tion. Click on “acknowledge” to clear the error (see Administration:

Notication of Errors, page 28). If the error condition persists, the

error will be signaled again after clearing the error.

WARNING: If a “System Thermal Fault” occurs, be sure that the

control module is not exposed to conditions beyond its ambient air

specication of 104°F, 40°C.

WARNING: In order to protect the electronic circuitry from damage,

the control module introduces a delay after experiencing an amp

short before turning the amp back on. A persistent short will result in

the amp being turned off once again. Shorts are most likely to occur

during installation of the system due to termination mistakes by the

installer. Shorts are unlikely once the control module is operational.

MCS: Administration Section

The following section will use gure 14 for reference.

Figure 14: Administration Section

IMPORTANT: Only update one block at a time and press Submit!

Changes to blocks that are not submitted will be lost if a different

block is submitted.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Keine Kommentare

CAMBRIDGE QT Installationsanleitung Seite 27